When I reinstalled all the programs, I notice that WinsealXP had “NONE” in the ID area where LaserDRW and Corellaser would default to the old ID. I did it! +I Laser thanks for jump starting my brain! I have been working on this problem for hours. What other software are you using, the same plugin/settings are used for laserdraw too I believe.Īnyway your situation sounds exactly the same, if you haven’t tried changing it and would rather theorise whether it’s the solution or not that’s up to you. I have deleted all the INI files in all the software directories and the first number keeps popping up. This is from the old board that the software recognizes.
I occasionally get the wrong machine connected in my VM, when that happens I have to replace the serial/ID in corel accordingly to get it to work.Īll the programs complain, not just corel. I took note of it and put the the serial off the new machine in.
I noticed the serial number in corel didn’t match my original machine either. I bought a second k40, when I fired up corel it gave the same error ‘invalid ID’. Not sure I understand, have you actually tried to change it? Second, If you remove the number and plug the board back in, the same number comes back. Wish it was that easy! Did try but if you look at the number on the old board, it does not match the number in the ID field. Click the gear icon in corel and down the bottom left is the ID/Serial field. Your board has a serial number on it, you need to put that serial number into the settings in Coreldraw. Maybe the USB key? It does not seem to read the new cards’ ID. This means that the ID is hidden somewhere I cannot find it. If I put the old card in, the software says it is initialized. Totally removed all software with removal software to get every bit, swapped USB inputs and watched it reload drivers, searched the registry for any sign of old ID, removed old ID from INI files in file directories and still no luck. A message that says “engraving machine connected.” is shown when starting the software. I keep getting this message “engraving device information invalid device-id cannot use it!” after trying to initialize the laser. I received my new M2Nano board and have been trying to get the software to recognize it.